my car has 3.90's in it, and they are even freshly installed. but i only have like 20 miles on the car....so not enough time to add good feedback yet, but i will more than likely be putting a few miles on it here fairly quickly.
my car has 3.90's in it, and they are even freshly installed. but i only have like 20 miles on the car....so not enough time to add good feedback yet, but i will more than likely be putting a few miles on it here fairly quickly.
i wanted 3.90s because its the best gear for my car. I can still trap at 130 on a 26" tall tire and not have to over rev the engine. I was thinking about 3.73s but it woulndt have been worth it comming from 3.55s. 4.10s would have been good but thats to much gear on for the top end IMO. if my IRS was stock agian I would goe with 3.90s agian.
Unless Brakelate is thinking of never hitting the track (so far he hasnt), 3.90's might be the gear's for his HP level.
4.10's @ 2710' is perfect...go through the ET lights around 6200rpms...Sea Level, the motor with the eaton will be screaming!!!
Jay...you can power shift 5th and she still pulls , but do the 3.90's
So, the 4.10's and a Steeda Diff cover brace went on two days ago.
Phocking thing vibrates so bad from 70-83 mph that I can't even tell what I'm looking at in the rear view mirror. That's right in my freeway cruise speed range, so it's frustrating. Before everyone starts blaming the installer, it seems that the two or three other locals running 4:10s have the same issue, right at the same speed.
At present, I'm regretting not going with the 3.90's. At least that would have reduced the vibe, or at the very least moved it up to over 85.
Hoping that in another two weeks I'll be holding a time slip with some nice numbers that will wash away the current frustration.
On the other hand, if I drove at legal speeds (almost impossible out here on desert highways) I wouldn't have a complaint in the world.
*Question: Does everyone with aftermarket gearsets leave the big weight on the front of the diff? Most appear to have been removed by the shop installing the gears, as it was "tuned" to remove vibes with the 3:55's. Mine is still there.
SlowOne....my stock CAR with NO MODS in it Vibrated at 80mph. Took the weight balancer off and no change in vibrations in RPM's.
Also, shorter Gears will pronounce any unsuspecting vibrations that was not there before or noticeable due to the increase in RPM.
BTW: U cheating BASTIG!!! I didnt know you had them Gears, but It didnt seem like
Just get a TUNE!
did you get a tune to fix your MPH? its off if you didnt. I never removed to weight so im not sure if it will help in your situation. no vibs here