Procomp Distributor

[MOTANGT]

1986 LX 5.0 HO. Bought a Procomp distributor and the housing is to wide to clear the fuel rail? Anyone run into this problem with an aftermarket distributor?

[4Jenna]

or if its just the plastic portion of the dizzy, upr makes a slim housing. Mine rubbed on the body of the dizzy so i had to get the rails that kick out for clearance.

[MOTANGT]

The housing is a full billit body on the one I have. What brand are those fuel rails and where do I find them? Those would be perfect.

[4Jenna]

http://www.behindbarsracecars.com/specials.html

[MOTANGT]

Thank You:)

[RogerL]

Procomp distributors are are nice looking but they have too much curve and lousy parts within. Spent quite some time reworking one.

Hope yours works better.

[MOTANGT]

So far it works just fine. A new $60, all billit distributor how can you go wrong:)

[pete]

So far it works just fine. A new $60, all billit distributor how can you go wrong:)

Hmm, maybe when the TFI module goes bad and takes the MSD and coil with it. Luckily for me I was running this on a carb set up so I went back to the factory distributor but still had to replace the MSD (trying out the Summit unit now) and coil.

It was also machined wrong and I could not use the Oring so it weeped oil. A buddy has a conventional distributor that had hte same issue but at least his is still running ok.

I do like the two piece shaft though.