Not sure which version I have. I got it in October or so. I have the adjustable handle which might make a difference.
Not sure which version I have. I got it in October or so. I have the adjustable handle which might make a difference.
2012 GT500 543/533 11.7@120
1995 5.0 minute or two per lap
Anyone have the MGW shifter in their 05+. Is your shift boot getting sliced up un the drivers side from the coupler for the handle??
2007 Tungsten Grey Mustang GT
Tuned by Extreme Performance
Adj UCA & LCA's, CAI
18x9 18x10, 265/45/18 + 295/45/18
Concept hood
JBA LT's, Pypes HF cats, 2nd rev. Flowmasters
MGW short throw.
No problems with mine. I had the PRO 5.0 on my 06 and my 07 came with the Roush short throw. The MGW is hands down the best of the 3.
2012 GT500 543/533 11.7@120
1995 5.0 minute or two per lap
How new is the MGW shifter that you have? Just wondering if there is more than one revision for this shifter. The block is really thick and comes to .120" from the console wall without the boot. I should probably take some stock off of the drivers side. Thank you for your responce.
2007 Tungsten Grey Mustang GT
Tuned by Extreme Performance
Adj UCA & LCA's, CAI
18x9 18x10, 265/45/18 + 295/45/18
Concept hood
JBA LT's, Pypes HF cats, 2nd rev. Flowmasters
MGW short throw.
My Pro 5.0 did the same thing...
Last edited by Blackmagic1; 07-02-09 at 10:11 AM.
I milled the side down and put the boot back in but there is still clearance issues. The boot sits so low in the pocket that it folds its self over making the Pleather thicker. I don't think there is a resolution. Oh well, boot comes back off again.
2007 Tungsten Grey Mustang GT
Tuned by Extreme Performance
Adj UCA & LCA's, CAI
18x9 18x10, 265/45/18 + 295/45/18
Concept hood
JBA LT's, Pypes HF cats, 2nd rev. Flowmasters
MGW short throw.