Car: like to get 1600.00
sub frame connectors (not installed)
Auto meter phantom gauges water and oil
5 lug disk brakes (94-95 cobra)
95 cobra master cylinder (just installed)
93 cobra brake booster (just installed)
PA racing tubular K member
PA racing tubular A arms with spring perches
Moroso trick front drag springs
Lake wood 90/10 struts
Fluidyne 4 core alum rad.
manual steering rack
HPM camber/ caster plates
battery box ( i made out of stainless steel)
aod drive shaft
t-5 drive shaft
130 amp alt.
mis. brackets
3 sets of fron brake pads (one installed one in box one used)
stock upper rear arms
upper and lower rear arm braces
Fuel cell (12 gal?)
stock fuel tank (no pump)

Motor 1200.00
(2) 460 blocks one cleaned has been baked and shot pinned (needs .60 over) mocking block. one ready for (.30)
(1) 429 crank turned and polished and machined for 440 dodge rods
(8) 440 dodge rods machined for pistons and crank. beamed and shot pined.
Polished TRW .30 pistons (13.2:1)
Ported (big time) weland stealth intake
Ported DOVE heads, big valves, heavy springs, fully machined..
Holley tall valve covers
Crane 1.7 Rockers
SFI flex plate
high torque mini starter
Manley push rod guides
Manley push rods
Ford motor sports all steel damp.
Speed pro bearings (crank and rod)
Speed pro rings
Ford heavy duty oil pump drive
Edelbrock performer trimming chain
Custom ground solid cam (lift - In/ Ex .665 )( dur @ .50- In. .272 Ex .282) (108 center line) MUST USE BOSS 302 LIFTERS!
long tube headers/ with turn down mufflers
BBF motor mounts
1969 Lincoln C-6 with drive shaft
will sell all for 2500.00 need money for my jet boat..
in
Thats right i am alive.... i lost interest in my high school car.. I am about 2500.00 away from finishing the motor in my jet boat need it done... pm if you have any ?.