$25 local pick up only
Results 1 to 10 of 10
-
03-16-09, 09:34 PM #1Super Moderator
- Join Date
- Dec 2005
- Location
- Phoenix
- Posts
- 1,224
FS: Autometer daul gauge pillar pod 03-04 cobra
-
03-17-09, 12:28 AM #2Senior Member
- Join Date
- Nov 2006
- Location
- Phoenix
- Posts
- 422
This will fit on my Mach right?
Arizona's Fastest Mach 1
11.14 @ 120 w/ 1.48 60'
GO-FAST MODS
Magnaflow O/R X-Pipe
Magnaflow Catback
Steeda CAI
Torch Red JLt Intake Tube
Steeda Tri-Ax
Spec Stage 3 Clutch
Built 31 Spline Rear w/ 4.10's
Rear Upper and Lower Control Arms
NX Wet Kit (100 Shot)
SCT Chip
Custom Tune by PSR
-
03-17-09, 11:08 AM #3Super Moderator
- Join Date
- Dec 2005
- Location
- Phoenix
- Posts
- 1,224
I'll check, but I think these were specific to the 03-04 cobra a pillars. They are thicker.
-
03-18-09, 06:47 PM #4Senior Member
- Join Date
- Mar 2006
- Location
- Tucson
- Posts
- 840
-
03-19-09, 05:07 PM #5Super Moderator
- Join Date
- Dec 2005
- Location
- Phoenix
- Posts
- 1,224
2 1/16
Originally Posted by el jefe
-
03-19-09, 06:41 PM #6Senior Member
- Join Date
- Mar 2006
- Location
- Tucson
- Posts
- 840
-
03-19-09, 08:56 PM #7Super Moderator
- Join Date
- Dec 2005
- Location
- Phoenix
- Posts
- 1,224
$25 bucks and see lol.
Last edited by Gene; 03-28-09 at 09:11 PM.
-
03-25-09, 04:38 PM #8Senior Member
- Join Date
- Mar 2006
- Location
- Tucson
- Posts
- 840
-
03-26-09, 04:19 PM #9Super Moderator
- Join Date
- Dec 2005
- Location
- Phoenix
- Posts
- 1,224
Originally Posted by El Jefe
Drill 4 holes into your stock a pillar and uses 4 small xmas trees. I'll measure when I get home
-
03-28-09, 09:11 PM #10Super Moderator
- Join Date
- Dec 2005
- Location
- Phoenix
- Posts
- 1,224
The hole diameter is 2 1/16, just measured. If you dont want it, ASUMC it's yours for $25. I said 20 in a reply, but that was a typo, its $25 since it's in mint condition.
