Stroker little 2V

[Dalamar]

Painted the rear Cals, they turned out better than I thought.





Pedal assembly showed up!
Got the old Single assembly out, they sent me the wrong fork, so I"ll have to get another one...







Started on the NOS stuff,
I didn't like how the NOS soloniods were all seperate, so I got a bunch of fittings,
hooked them up in a nice neat little cluster, and made a mounting bracket.


Nitrous inlet to all 3
lines out for dry shot, wet shot and purge





Seems like I have a lot more to do!

[ReaperAZ]

Wooohoooo, you're getting there man.

[Dalamar]

Update:

Got the nitrous lines customezed and hooked up.

Tranny's in, but I need to modify the crossmember.
Pedals are in too

Spaced out my rears 1/2"
Looks way better.










Love the look!
May have to roll the fender lip, we'll see.

Notice the spacer has the hub extension. Hubcentric - so you're wheels not riding on the studs only!

[Tac2cul]

any new progress?

[vicious781]

Sure hope you're switching out that plastic intake manifold if you're running nitrous.

[Dalamar]

Some progress.

Running the PI for now, I'll be looking at the new Trick Flow when it is released.



Still putting things together...
It's mostly all reassembled. Got the tranny and driveline in last week.
Had to modify the crossmember, then it went right up.
Also got a remote bottle opener, next I get to start all the wiring for the nitrous parts!!

[Dalamar]

Update pix:

Installed the Maximum motorsports oil filter relocation kit.

Heres the block port


you cut the hose to length and these neat fittings pressure crimp as you tighten them.


Couldn't get a really good shot, but here's where the filter sits. I like it

[Dalamar]

Put on the MM pinion snuber, it's shorter since I'm riding low. It won't bottom out as soon when the back seat is full of women.
Good shot of the driveline spacer too.


The ultimate LCA's - twin spherical bearings

The torque arm also arrived.
Man MM is awsome, I ordered this stuff monday, and it arrived wensday!


I think I'll be installing that AFTER it's running and tuned.
Installing all this stuff is a full time job! but I'm getting close.

[Dalamar]

Here's where I'm at with the NOS wiring-
RPM window switch, relays that open the solonoids, supply to the opener and wiring.
I mounted it on a plate thats going in my console, then under to the switches, and wires front and back. :)

[Dalamar]

Installed the MM torque arm and LCA's over the weekend.

Getting Closer !!