I have a 03 mach 1 with 7550 miles on it that I'm about to S/C . Only an Eaton M-112 for now but will probably upgrade later. Maybe nitrous later also. My goal for the street is 600 rwhp but I do not want to worry about the bottom end if I put nitrous to it. SO from what I have been able to figure my crank is a forged unit since I have a manual trans, that should be O.K. But what about pistons and rods? I have been looking at the 4340 h-beams rods with ARP cap screws. With Mahle 16 cc dish pistons. Should be around 9:1 with my stock heads? Looking for help/advice on selection of all three components.
Thanks Greg