I need a Cobra Drive Shaft

[wickedcobra]

I know its a long shot but does anyone have a 03-04 Cobra Drive shaft laying around?

[BurnTire]

I just happen to have one in the garage.

It does not have the tranny yoke.

Went 10's LOL.

[wickedcobra]

Let me clarify my request......I need a Drive shaft that is not twisted all to heck!

[BurnTire]

Let me clarify my request......I need a Drive shaft that is not twisted all to heck!

The drive shaft is not twisted and was fine when I took it off the car.

I got a longer shaft to increase the yoke engagement area.

If the shaft was junk I would throw it out.

I do have the old yoke but being it was involved in the output shaft damage I would not recommend using it.

[boss 331]

hey jeff, do you still have that driveshaft laying around? I may be interested. I know I am new here, but this post is how I found this forum. I've got a 95 and I am doing a t-56 swap and needing a driveshaft. How much for it and to ship to 37122? I don't need the front yoke. thanks
boss 331

[AZSonicSnake]

soo...anyone else got one layin around? found out while doing a ujoint swap that mine is peaced out...

[wickedcobra]

good luck Tony! nobody has one around. Just order one from dynotech. about $400 bucks. I can get you a new one from ford for just over $300 at employee cost

[BurnTire]

good luck Tony! nobody has one around. Just order one from dynotech. about $400 bucks. I can get you a new one from ford for just over $300 at employee cost

What length did you get?

[AZSonicSnake]

good luck Tony! nobody has one around. Just order one from dynotech. about $400 bucks. I can get you a new one from ford for just over $300 at employee cost

was gonna send ya apm, but says you can't get them. weird.

think i am gonna go this route. but i hit up sanderson, and they did not have one, and it looks like no one in town has em, new or used. how long would it take you to get it? sanderson quoted me like 340 for it.

thanks man.

[AZSonicSnake]

yeah, thinking about just throwing the stock shaft back in there. its worked till now. the only issue was the ujoint end caps just falling out when i pulled the clips. doh!