roll cage is in

[Blownsvt]

Heres a few crappy pics. wife has the better camera so these will do for now.











for some reason though my wide band is not working right. it turns on but won't take a reading. just sits with 3 lines on it and topped out on the lean end. any ideas?

[BurnTire]

Looks good. Are you going to keep the stock seats? I swapped mine out for some racing seats with shoulder and crotch cutouts because it is unsafe to route anti sub harness over the front of a stock seat.

[About2Bite]

Very Nice

Are you going to paint it?

[ttocs]

why is the back seat in?

[Blownsvt]

Looks good. Are you going to keep the stock seats? I swapped mine out for some racing seats with shoulder and crotch cutouts because it is unsafe to route anti sub harness over the front of a stock seat.

I would like to but time will tell. I like the red and black you know.

Very Nice

Are you going to paint it?

Not sure how i would now that it;s in the car without making a huge mess inside the car. would have been nice if they would have done that during the install.

why is the back seat in?

got to put the kids somwhere. also it acts as a sound deadner for the rear end and the ungodly loud fuel pump.

[About2Bite]

Not sure how i would now that it;s in the car without making a huge mess inside the car. would have been nice if they would have done that during the install.

One of my buddies in Indiana painted his once the cage was installed, they gutted everything though and just put a racing seat on the drivers side. Everything else was tapped off, the cage was prepped and then painted. It'd probably be a pain to pull all that out and put it back in, and the car smelled like paint for like a month and a half lol

I think most are done once the cage is installed, you could always polish it