So I'm pulling the transmission on my mach 1 for a new clutch install. I've got the transmission drained, drive shaft out, starter out, mid pipe out, and have removed the five bolts holding the manual transmission to the engine and the bottom two. The shifter is completely removed and all sensors are disconnected. The motor is supported at the by the oil pan with a jack and a 2x4, and the transmission is supported back at the tail. I cannot for the life of me get this transmission to budge. :SMASH: I've never had a problem removing a transmission, though I've never removed one out of these cars. What in the world could I be overlooking? I feel like an idiot, but everything else went by so smoothly.