BentTire is again Burntire

[BurnTire]

Yeah!!! Finally I better see that at the show too!!

I talked to Dan briefly the other night about a Dyno-Day at PSR with CMC and Wild West... Test Session???

Sounds like a good event to do prior to it getting too hot outside.

[ASUSMC]

Sounds like a good event to do prior to it getting too hot outside.

I agree. Maybe my vehicle will make it off the dyno before blowing up.

[BurnTire]

I agree. Maybe my vehicle will make it off the dyno before blowing up.

LOL.

I have a nice set of used subs that are going to be getting replaced with full lengths. Do you need a set?

[ASUSMC]

No I need a Lightning motor.... Got one?

[Dan]

I believe mine is powder coated, so yeah what up now?

yes shaggy yours is semi gloss and jeffs is clear

[El Jefe]

Nice bling bling!!

[WildBill]

ya you're welcome too bent-tire, maybe i should have let some of those pretty little sparks on to those nice seats you got...lol

Yeah.........He forgot who took his BENT REAR to Daryl Smith too.

[BurnTire]

Yeah.........He forgot who took his BENT REAR to Daryl Smith too.

Thanks to Wild Bill and Bad Shot in the office!

[Blownsvt]

are you on an 8.8? i persnally went with a ford 9" and had everything welded up the other day. i am sure that sucked having to rip it out and re do it.. I am tyring to make everything as solid as possible right from the get go.

[BurnTire]

are you on an 8.8? i persnally went with a ford 9" and had everything welded up the other day. i am sure that sucked having to rip it out and re do it.. I am tyring to make everything as solid as possible right from the get go.

Yes I have an 8.8 that is now more expensive than a good 9" setup.