Ok now keep in mind I am just messing around . I have been porting for years and this is not something I like to do however I wanted to see it these intakes will make power. So I bought on and cut it up to see what makes them tick and I found a bunch of crap in side. There was a lot of casting flash that we removed . I have not gone threw and painted this or any thing this is a raw picture. And detailed pictures of the inside of your intake. Take a look. We normally port heads not intakes, But as you can see it does not take a rocket scientist to get the job done. We have enlarged quite a few areas that we feel would improve air flow.

Ok guys here are some shots on my little port work
First this is stock



Now this is what it looks like now









Here is the one port that is almost closed off I have opened it up so it too can now add air to the motor. This was the only restricted port I seen
This is what it looks like now


Here are some more of the runners


And some of the top side