Probably a few weeks after the 14th I will get it in.
Results 11 to 20 of 160
Thread: Dec 14th Firebird
-
11-26-07, 10:03 PM #11Administrator
- Join Date
- Dec 2005
- Location
- Pittsburgh, PA
- Posts
- 8,619
Sold
2004 Cobra, Whipple ,TH-400
Burning Corn
9.97 - 135.5
-
11-26-07, 10:08 PM #12Senior Member
- Join Date
- Apr 2006
- Location
- North Phoenix
- Posts
- 4,184
jeff wants a k-member. damn good way to spend some money. one of my best investments on my car...
-
11-26-07, 10:30 PM #13Senior Member
- Join Date
- Nov 2006
- Location
- Phoenix
- Posts
- 422
I might make it out if the car is ready for racing by then. Well I should say if the check book allows the car to be ready by then.
Arizona's Fastest Mach 1
11.14 @ 120 w/ 1.48 60'
GO-FAST MODS
Magnaflow O/R X-Pipe
Magnaflow Catback
Steeda CAI
Torch Red JLt Intake Tube
Steeda Tri-Ax
Spec Stage 3 Clutch
Built 31 Spline Rear w/ 4.10's
Rear Upper and Lower Control Arms
NX Wet Kit (100 Shot)
SCT Chip
Custom Tune by PSR
-
11-27-07, 01:02 AM #14Senior Member
- Join Date
- Jun 2006
- Location
- PHX AZ
- Posts
- 701
I might be able to make it out that weekend.
The last few times I went to Firebird it seemed to hook pretty good, atleast for my slow
.
-
11-27-07, 01:05 AM #15Senior Member
- Join Date
- Nov 2007
- Location
- Gilbert
- Posts
- 726
I was hoping to head out this Friday, but it looks like it is going to rain so I doubt that will end up happening. So I've got a feeling that the 14th might end up being my next outing. Then again, if it doesn't rain this Friday, I may just do both the 30th and 14th
-
11-27-07, 01:12 AM #16Administrator
- Join Date
- Dec 2005
- Location
- Pittsburgh, PA
- Posts
- 8,619
They are also open the 7th.
Sold
2004 Cobra, Whipple ,TH-400
Burning Corn
9.97 - 135.5
-
11-27-07, 01:47 AM #17Senior Member
- Join Date
- Sep 2006
- Location
- Phoenix
- Posts
- 1,024
I might go watch you guys but as far as racing I am no longer going to be racing my Gt, Im saving up money for a project car and when that is all said and done, I will hopefully be bringing that out
-
12-01-07, 03:06 PM #18Member
- Join Date
- Nov 2007
- Location
- arizona
- Posts
- 56
sure ill be there, i though as a spectator only unfortunately
-
12-01-07, 03:44 PM #19Senior Member
- Join Date
- Oct 2007
- Location
- Tempe arizona
- Posts
- 275
i'll be there on dec. 14th
-
12-01-07, 07:13 PM #20Senior Member
- Join Date
- Aug 2007
- Location
- QC/Gilbert
- Posts
- 1,405
I will be there. Hopefully the Solid axle install will be complete.
Reply With Quote
