Results 1 to 7 of 7

Thread: O/R x or H pipe

  1. #1
    Junior Member
    Join Date
    Oct 2007
    Location
    League City, TX
    Posts
    9

    O/R x or H pipe

    Im lookin to put a O/R x or h pipe on the car but my car seems to have manifolds, is this gunna pose a problem with the fitment? any info would be great!

  2. #2
    Administrator BurnTire's Avatar
    Join Date
    Dec 2005
    Location
    Pittsburgh, PA
    Posts
    8,619
    Should bolt right up with no problems.
    I went back to cats. I can't stand the fumes from an O/R.
    A good set of high flow cats will give the same power results as an O/R pipe.
    Sold
    2004 Cobra, Whipple ,TH-400
    Burning Corn
    9.97 - 135.5

  3. #3
    Senior Member Indy's Avatar
    Join Date
    Jun 2006
    Location
    PHX AZ
    Posts
    701
    My off road h-pipe showed no gains over my stock h-pipe, but it sounds ten times better!

  4. #4
    Junior Member gip99gt's Avatar
    Join Date
    Oct 2007
    Location
    Dallas, Tx
    Posts
    23
    It all depends on what sound you like. Take a ride with someone with a O/R H. Then take a ride with someone with a O/R X. See which one you like best. I have had both and the x sounds best at high rpm's.
    04 Laser Red 5-Speed GT Mods:
    BBK Plenum * BBK 75mm T/B * BBK Cold Air Kit * H&R Drop Springs * Steeda Tri-ax Shifter * UPR C/C Plates * MAC O/R H * Flowmaster Mufflers * Diablosport Tuner * NGK TR-6 Plugs

  5. #5
    Member sesso's Avatar
    Join Date
    Feb 2008
    Location
    Tempe, AZ
    Posts
    72
    Ya i switched to the X and i think i like it better.
    2005 GT Mustang 5 spd, Shaker 1000, Short Antenna, JBA Headers, JBA O/R X pipe, BBK TB 62mm, C&L CAI, Diablosport tune, BMR LC Arms, Pro 5.0 Shifter, ZEX Nitrous 125 Shot, 4.10s.Coming soon: cams or 5.4 swap

  6. #6
    Senior Member BUSTED's Avatar
    Join Date
    May 2008
    Location
    Arizona
    Posts
    272
    i have a o/r x because they make more power....as long as it is a REAL X-pipe (NO BBK or BASSANI TYPES). Those press formed X-sections dont do you any good. the whole purpose is to create a vac. affect and suck more exhaust gas from infront of the x section. look at Dr. Gas X-pipes or even the new Pypes Stainless ones these are correct styles to create the most vac. and scavange from the headers which allows the exhaust to be sucked out thus flowing more and make the most power .....h-pipes are a waste as stated above other than a louder exhaust note....which the x-pipes give you too.( but better). H-pipes level out the exhaust pressure but its bassically an out dated tech. The inside of a REAL X PIPE has trade secret angles before and after the x section (with a Sharp divide in the center) to flow/scavange the best.
    Last edited by BUSTED; 06-05-08 at 01:54 AM.

  7. #7
    Senior Member About2Bite's Avatar
    Join Date
    Feb 2008
    Location
    Chandler AZ
    Posts
    504
    The power gains between the two are minimal, get what you think will sound better. An H pipe has more of the muscle car sound where as an X seems to be a bit more exotic sounding, X pipes also tend to be a bit more rhaspy without cats depending on your catback, what catback are you running currently?

    Depending on your emissions an o/r mid pipe might end up bring a pain.
    Black 04 Cobra

    KB 2.2 @ 19#'s, 3.25(15#) upper, 4# lower, CAI, Kooks LT's, Catted H,
    SLP LM1 CB, 60# inj, BF idlers, BF TB, Zoom ZVT Stage 3, 26 Spline, MGW,
    2400 MAF, Ron Davis Racing HE, SCT tune, AFS 10.5, 315/35/17


    Quote Originally Posted by wickedcobra View Post
    I have it worked out with my wife too, I get car parts, she gets brooms, vacuum, irons etc....LOL

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •