'03 Cobra mods - winter 2007

[BADASS03SVT]

shifter mounting brackets



then to put in the shifter and adjust the height...PITA btw...

[BADASS03SVT]

and some dynomat to seal up the sides of the shifter and dampen some noise

[Viper_ed]

also got the rear end to DMC for Strange 33 spline axles, Strange Pro Diff, Strange 4.11's, 9" ends with big bearings and Ford Explorer brakes. Denis is also going to run axle braces from the tubes to the pumkin.

I went with the same brakes when I had the rear for my 88 GT done. Here's a pic of the axel tube supports I had done on mine. There's a member on turbomustangs.com (snoopstang) that sells them for $99 shipped. I know he post on numerous Mustang Boards under the same name if you want to contact him. All of the components are top notch.

[BADASS03SVT]

B&M tranny cooler. Got it mounted behind the bumper cover. hsould be able to get some air form the open ducts next to the fo glights.

[BADASS03SVT]

got the PI converter installed. Make sure it is seated! I learned the hard way. No matter how silly the directions sound...use them!


Tranny in the car and the deep pan installed!!

[BurnTire]

Looks Good!

[Viper_ed]

That is one SERIOUS ASS LOOKING Tranny Crossmember!

[BADASS03SVT]

Shifter, new switch installed and 99% of the wiring done...

[BADASS03SVT]

Cooler fully mounted and braide dlines run

[BADASS03SVT]

Spring on my clutch pedal...yes...the clutch pedal is still in. It will be utilized as the Trans brake switch. Th elittle switch under the dash is to kill the power to the pedal in case of accidental touching while on the street