302/351 bare block needed. any condition

[pcmpete]

Hi all, new to this forum. I don't own a Mustang but i do use a 302 motor in one of my boats.

I am rebuilding the transom/stringers of that boat and need a 302/351 bare block to fit my mounts to so I can build the stringers in the correct position and height.
The can be cracked, I don't care. It would be easier for me lifting the block in and out of the boat for measuring and trail fitted rather than the full engine.

Let me know what I you have got and what you are looking for it.

Thanks

[SloSVO]

I have 302 shortblock that i'm about to throw away.. if want it you can have it.. its in glendale..

[pcmpete]

yeah, i'll take if, what weight do you think it is?

[SloSVO]

I would say about 200 lbs.. roughly.. if you have some tools you strip it down there and toss everything in the dumpster thats 15ft away.. it was actually a good running motor.. I'll be at the shop tomorrow..

[pcmpete]

I am up in the Cave Creek area, but I will be down in Glendale later this week. Do you think that the two of us could lift it in to the back of a SUV? I could hoist it out at my end.

My number is 530 848 7819

Thanks