Damned good week this week. Only thing between us and some Dyno time is wiring and installing the fans and radiator, then hooking the cooling system up to it. Here is the plumbing hooked up except for the radiator and the rear mounted heat exchanger. We will probably work on the hoses to clean them, up but I am very pleased with the setup as is.
Results 21 to 30 of 233
Thread: 2004 Pontiac GTO!
Hybrid View
-
07-30-11, 11:14 PM #1Senior Member
- Join Date
- May 2010
- Location
- Texas
- Posts
- 196
-
08-26-11, 10:05 PM #2Senior Member
- Join Date
- May 2010
- Location
- Texas
- Posts
- 196
Looking at the Roll Cage Install today and noticed the CPU relocation was clearly visible. The shots I took at the time of install were mostly of my friend using foul language. Enjoy
-
09-03-11, 07:15 PM #3Senior Member
- Join Date
- May 2010
- Location
- Texas
- Posts
- 196
Finally finished the Alternator wiring to the Kill Switch today.
-
04-07-11, 12:49 AM #4Administrator
- Join Date
- Dec 2005
- Location
- Pittsburgh, PA
- Posts
- 8,619
Getting to be 1/4 mile time soon.
-
04-07-11, 07:14 PM #5Senior Member
- Join Date
- May 2010
- Location
- Texas
- Posts
- 196
Really soon. Waiting on one more piece for the cogs, then the rollbar
-
04-09-11, 07:01 PM #6Senior Member
- Join Date
- May 2010
- Location
- Texas
- Posts
- 196
Started on the remote water pump installation today. I am eliminating the tensioner on the passenger side and wonder if anyone might know of an aftermarket tensioner I can replace the fixed tensioner on the driver's side with?
Before
After, sorta
-
05-31-11, 11:11 AM #7Senior Member
- Join Date
- Jun 2006
- Location
- PHX AZ
- Posts
- 701
Nice build, looks like it should be a beast on the track!!!!
-
06-03-11, 09:39 PM #8Senior Member
- Join Date
- May 2010
- Location
- Texas
- Posts
- 196
We intend to finish the battery wiring tomorrow, mount all the fittings for the water pump, and the coolant reservoior in the trunk. Wednesday we will hook up the hosing and have the final meeting with the machinist who is designing and building the tension pulley bracket. Hope to be tuning in a week or two. Really quality welding getting the PS reservoir bracket set up and notching the valve covers/welding in tabs so they won't slide and welding in the 90 degree fittings for the evac system.
-
06-04-11, 11:47 PM #9Senior Member
- Join Date
- May 2010
- Location
- Texas
- Posts
- 196
Quite a bit done today. Finalized the electrical system setup with the rear moutned battery. We should have that in in a couple of weeks. The welder finished most of the valve covers and the evac system. Also got the water pump bracket roughed in. Going to mount it along the passenger side frame rail where the battery came out using battery tray holes. Running the outlet down through the frame and bending it 90 degrees into the engine compartment.
-
06-12-11, 12:09 AM #10Administrator
- Join Date
- Dec 2005
- Location
- Pittsburgh, PA
- Posts
- 8,619
That is coming along nicely.
Reply With Quote