FS: Weld Draglite Slicks and Skinnies

[TorchedMach1]

Well I'm putting my drag setup up for sale. I wanna go with a new setup for the up and coming race season. There is still a lot of tread on both sets of tires. The rears are drilled and screwed and have tubes. Rears are 15x8 with a 4.5" backspacing and fronts are 15x3. Rear slicks are 28x9 M/T ET Drags, fronts are 28x7.1 Moroso drag specials. I will also throw in a set of 28x7.5 M/T Sportsmans. The Sportsmans do have some slight cracking, but I ran them just fine. They will also come with center caps and lugs/washers. I was pulling bottom 1.4x 60' on this setup!!

SOLD!!!!!

[Jodaddy]

Bump for a sweet set of slicks and skinnies, too bad im a broke b!tch or i'd get them.

[TorchedMach1]

Price Drop!!!!! $500.00!!!!!

[trucker]

did you have to spacer these to put them on your car ?
was just wondering if they would fit a 06

[TorchedMach1]

did you have to spacer these to put them on your car ?
was just wondering if they would fit a 06

I did have to use a spacer to put them on the front, but the rears where fine. Not sure if they will fit an 06. PM me and you can swing by and try them on to see if they would work. I have all the stuff here to do it.