Page 3 of 3 FirstFirst 123
Results 21 to 25 of 25

Thread: Downpipe...

  1. #21
    Member mntony's Avatar
    Join Date
    Jul 2006
    Location
    Surprise, AZ
    Posts
    91
    I've used the cutoff wheel and found it difficult when it comes to rounded corners. The best advice I can give you is to suck it up and start cutting! You can't finish if you don't start! LOL

  2. #22
    Senior Member Mr. Austin's Avatar
    Join Date
    Apr 2008
    Location
    Peoria
    Posts
    1,622
    Here is where I am at.

    Name:  DSCN0459.jpg
Views: 616
Size:  26.5 KB
    Name:  DSCN0460.jpg
Views: 624
Size:  33.9 KB
    Name:  DSCN0472.jpg
Views: 592
Size:  19.2 KB

  3. #23
    Member mntony's Avatar
    Join Date
    Jul 2006
    Location
    Surprise, AZ
    Posts
    91
    Man, that is going to look good!

  4. #24
    Senior Member Mr. Austin's Avatar
    Join Date
    Apr 2008
    Location
    Peoria
    Posts
    1,622
    Have any Ideas on how to fix the dent you see on the front of the hood? you can tell by the sand marks where the dents are.

  5. #25
    Member mntony's Avatar
    Join Date
    Jul 2006
    Location
    Surprise, AZ
    Posts
    91
    Oh man, I'm not the person to ask about body work! I absolutely hate doing it. Those guys don't get paid enough in my opinion! But having said all that, if you can get in behind it then a body hammer and anvil would be best. But I'm guessing that is not the case. Short of that there is always trying to shrink the metal. What happens when you get a dent is that you usually end up stretching the metal and trying to get it flat again is the challenge. Shrinking involves heating up the metal and quenching it very fast. The problem is that you don't want to distort other parts of the hood as well. But like I said, I am certainly no expert with bodywork.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •