Clutch and Roll Cage Project Cliff Note Version

[BurnTire]

To keep the tech Nazis Happy

[Lucafu1]

where did you get that at?

[BurnTire]

It is a wolf race craft crotch strap bracket I wasn't using. I had to fab up the spacers between the bracket and the cross bar. NHRA said drilling the holes into the cross bar is fine as long as you have a sleeve around the bolt to prevent the cross bar from crushing or use a nut with nylon and don't over tighten the bolt.

[Lucafu1]

nice work!

[BurnTire]

If I ever put a racing seat in the car I will fab up something that uses the bottom of the bolts to secure the back of the seat to the cross bar. The stock seats are a little too high. I find my head against the roof at times with my helmet on.

[BurnTire]

[autoxstang]

Quick question. Can you completely remove the swing outs or are they fixed to the bottom of the car?

[BurnTire]

You can completely remove them.

[autoxstang]

Awesome bro!! I really like your setup. I may model my car after yours if you don't mind

[BurnTire]

Awesome bro!! I really like your setup. I may model my car after yours if you don't mind

I don't mind.
Nothing custom about mine. It is the Maximum Motorsports Roll Bar with Swingouts.

Just make sure you get a tab welded to bolt the harness to the cross bar or weld on a bracket to prevent them from sliding on the cross bar if you wish to wrap them around. I wish I knew that before I did mine, but I found an acceptable solution without killing the powder coat.

I just ordered the Corbeau TRS seats. I test fitted at set and they work with the swingouts. I feel they are safer because they have shoulder and crotch belt holes in them and a little weight reduction never hurts.