i don't see it being too hard to just remove it and flip it around.. if its backwards
Results 11 to 13 of 13
-
03-26-10, 01:31 PM #11Senior Member
- Join Date
- Oct 2008
- Location
- Buckeye, Az
- Posts
- 586
-
03-26-10, 01:35 PM #12Junior Member
- Join Date
- Oct 2009
- Location
- Kingman, AZ
- Posts
- 10
Did not have lift, so rather difficult getting into that area from underneath.
-
04-01-10, 05:51 PM #13Senior Member
- Join Date
- May 2008
- Location
- Arizona
- Posts
- 272
I had a minute I thought I would go to UPR's website. Look at the way it is in the picture. There is no brace on the other side of the arm and it is also flipped over in UPR's relocation bracket. Again I'm about 100% sure this is an install mistake.
http://www.uprproducts.com/mustang-c...-mount-05.html
But on a side note, I'm sure it will work fine with the ding your tech helped put in your new part.
Reply With Quote