Motor is brand new, has been machine oiled but 0 miles
5.1 stroker
5 angle valve job Comp 791-16 titanium [COLOR=blue !important][COLOR=blue !important]retainers[/COLOR][/COLOR]
Comp 26125-16 behive springs
SI SS [COLOR=blue !important][COLOR=blue !important]valves[/COLOR][/COLOR] +1mm
valve seals
bronze/manganese valve guide

1628 comp cams
8.5 to 1 compression perfect for blower or nitrous
was setup for a kenne bell and would put you through the 1/4 sick quick with kenne bell

Listing of some of parts used:
arp head studs
arp main studs
7 qt canton oil pan
melling 1 inch oil pickup
performance mogul main and rod bearings
total seal stainless,gapless top rings
felpro gaskets
3 sticks of metal put in crank for balancing
aftermarket american made crank
H-beam rod 5.850 Length(early chevy)
Had to special fly cut pistons so valves would clear
Probe 18.1cc dish #10178 pistons
3.75 stroke
They call it a 5.1 stroker

This is straight from standard machine and roger(owner) would be more then happy to help you if you have any questions)

Website is http://www.standardmachinellc.com/

Buyer pays shipping firm on price: $5,000.00. This is a steal for brand new everything!!!! I doubt you could even build one for just parts for this(porting,polishing,boring,balancing and building done at standard machine). Another words they did everything lol.


This motor is located in park falls wi... Pictures can be seen here 2009 down at bottom: http://www.dropshots.com/maiers#date/2009

Jeff