terminator with squeez!!!!!!!!

[kbstang]

Any of you out there know what a stock blower terminator would run in the 1320 with a 100 shot of spray and maybe some times for a stage 5 ported eaton with a 100 shot. or any squeez combos.

[silvrsvt]

well IF I could keep a clutch in my car I could tell you what a 4,000lb vert runs with a stock blower on a 100shot. I can tell you with a 1.8 60ft I went 12.0 @ 115, I am hoping with the 100 shot I can go 11.30-11.40 @ 121-122

[AZSonicSnake]

well, my car is a stage 4 ported, and runs the number in my sig, and has more in it, but the whole "no cage" part gets me booted everytime.

[SloSVO]

Sonic, what size shot, if any, to run those times? you solid axle?

[AZSonicSnake]

Sonic, what size shot, if any, to run those times? you solid axle?

yes, i do have a solid axle. the suspension on my car coupled with the amazing tune, and a little bit of driver mixed in, is what makes it run the times it does, and trap just a hair over 129. and i am NOT spraying any nitrous at all.

[SloSVO]

what gears you running? and what is your drag wheel set up?

[AZSonicSnake]

running a 3.90 gears, and i hit the traps at about 6300 in 4th. for wheels, i run a set of prostars. 15x3.5 and 15x10 out back. as for tire, i have been running a 26x10 et drag slick.

[SloSVO]

you run the bolt-on spacer for the skinnies?

[AZSonicSnake]

nope, a 3/4" billet spacer is what i run. has worked fine for the past 2+ years. just needed some long studs.

[El Jefe]

Any of you out there know what a stock blower terminator would run in the 1320 with a 100 shot of spray and maybe some times for a stage 5 ported eaton with a 100 shot. or any squeez combos.

Anywhere between 10.20 and 12.80, depends on the driver