TH-400
Converter
JW SFI Flex Plate
JW SFI Bell
JW Crank Adapter
Bolts for Bell to Block
Bolts for flex plate to crank - Ford Auto Mach 1
Bolts converter to flex plate
Bolts for cross member to trans mount.
Custom Driveshaft
Dipstick
Trans Cooler
Cooler Mounting Hardware
Cooler Lines and fittings
Shifter
Center console kit if relocating shifter from stock position
Trans-brake button
Trans Temp Gauge
Speedo Solution -Click Here-
Discuss the install -Click Here-
Rossler Terminator 3 TH-400
Installing was way easier than a T-56. I was surprised how small the tranny was compared to a 6 speed.
Ultimate Converter Concepts 10" Converter
3700 transbrake stall.
Fill it with one quart of ATF prior to installing on the tranny.
Steel Deep Pan
(JW The Wheel) flex plate
Get flexplate bolts from an Auto Mach 1 as the six speed flywheel bolts are too long.
Converter Spacing was a little greater than 9/64" So about .140" which falls in the ranger of .125 - .187
This is without the stock starter index plate which is .073" thick. If the plate was used I would have had about .213" spacing which is too much.
To measure your converter spacing push the converter back into the tranny. Place a drill bit between the converter pad and flexplate.
Energy Suspension TH-400 Mount.
Drill out the stock crossmember.
Grade 8 Allen bolts and lock washers to fit in the tight area.
The bolts with the mount kit will not fit.
In the car. Motor angle is a few degrees output shaft down just like stock.
My trans B&M Hi-Tek Trans Cooler.
Mounted in the Drivers Sider Fender.
Thermostat Activated Fan, but I am going to wire it to run all the time.
Get some hanging hardware from your local hardware store.
Trans Cooler Lines. -6 Aeroquip
Hose routing under the fan then a right thru the tubular k member to the tranny
CSR tranny vent catch can. Fluid hose has to go up or down, but not both or it will act like a sink trap and not vent.
Lokar Dipstick
B&M Pro Ratchet Shifter.
Carbon Fiber Console kit.
Six speed boot will go around the shifter when complete.
Line Lock on the Right Switch
Trans brake in the hole for the left switch.
I trimmed a few edges on the shifter to fit the console plate better.
You have to cut some of the tunnel for the shift cable to pass thru.
Delete Panel
When all is done I will fill the shifter cable hole with some adhesive and insulation.
To setup your safety switch on your auto shifter you first need to locate the clutch safety switch on the left side of the clutch pedal. Pull out the connector. I took 2 male flat wire connectors and filed them slightly to fit into the female slots of the connector. Run the wires to your auto shifter safety switch and your done. You use the same concept for the reverse lights. Just tie into the two wires on the T-56 harness.
I ended up going with the T-Handle. I like it better than the ball.
vBulletin Message