PDA

View Full Version : Need HELP !!!!!


Phx99Cobra
10-13-09, 02:56 PM
This past weekend I was changing from an aod to a tko tranny in my car and ran inot a confussing problem. After installing the Clutch we put the Lakewood clutch fork in the Lakewood sfi bellhousing and attached it to the block. Well the fork is to short to engage the cable and the throwout bearing is nowhere close to lining up to the center.......Any advice is greatly appreciated as this is my only car and i am bumming rides from my friend right now.

The car is a 2003 gt, the clutch is an 11inch clutch
Dan
10-13-09, 05:42 PM
you need a 94-95 clutcch arm
Phx99Cobra
10-13-09, 05:49 PM
you need a 94-95 clutcch arm


What is this, where do i get it, and why does lakewood not know about this...

Thanks
Dan
10-13-09, 06:09 PM
Phx99Cobra
10-13-09, 06:23 PM
Thanks for the advice, if you come by one lying around the shop let me know
Dan
10-13-09, 07:23 PM
you would have to just show up and look. there is so much crap around here its hard for me to stop what i am doing to look for one