camber kit

[6568]

i am looking for a copy of the dr gas vario-centric camber kit installation instructions. anyone have a copy i can get.
thanks 6568

[BurnTire]

2bav8 (http://www.highperformancestangs.com/forums/member.php?u=177) may know.

[2bav8]

I should have a copy laying around.
Have you bought the kit yet?
I happen to have an extra one if needed.

[6568]

i do have the kit already,but i do have another 65 mustang i plan on putting it on if i like this setup. how do you like it and what do you want for it. you can e-mail me at;
thanks6568

tt7952@cox.net

[2bav8]

The kit is nice, with a set of adjustable length strut rods you can eliminate using shims for alignments. The kit is a pain in the butt to install as you have to grind and weld to install. Once its done, its a very nice upgrade.

[6568]

how much are you wanting for this kit.

[2bav8]

$40.

[6568]

i will take it. where are you located and when would it be good for you.

[2bav8]

Cross streets are Alma School & Baseline.
My schedule is pretty open, except for Saturday and Sunday this week.

[6568]

i work around elliot and arizona ave and i am 0ff between
3:30/4:30. i can swing by and get them on my way home let me know what would work for you. i have been looking at your car and i might know you.are you matt s from the cmc. i am terry with the dual quad 65 conv.

[2bav8]

LOL - small internet isn't it.
You're right by the Mustang Shop...

So, how about 3:30 - 4:30 on Wednesday?

[2bav8]

Hey, I just tore up my house looking for the instructions and I can't find them!
I have the kit, I went through it and its all there.

I'm going to keep looking for the instructions in the mean time.
Worst case, I can show and/or write them down for you.

[6568]

HOWDY NIEGHBOR.
that is funny, your car looked very familiar i just could not place it with the number on the side. sounds like a plan! i am just down a ways from the mustang shop on the other side of arizona ave by the railroad tracks. where would you want me to meet with you.