Machine Shop for Flywheel Resurfacing

[IMSHAKN]

Okay, so I am going to replace my clutch tomorrow and I need help finding a machine shop that can resurface my flywheel, preferably in the East Valley (the closer to gilbert the better). As I'm finding out, a lot of shops are closed on saturday. Anyone have some suggestions?

[silver03cobra]

PB MACHINE! Paul is a bad @$$! ask jeff.

He is at cave creek and hatcher! 602-997-2445

I think it is 30.00 (he washes it all so) Tell him Seth with the cobra sent you!

He has a lot to do so he will be there call him! should be there until 5:30. should be at the shop by 9am and will not answer 12 to 1pm (lunch)

[IMSHAKN]

I may just have to give him a call, but I'd really prefer something closer out my way because it's not going to be me making the drive...

[silver03cobra]

well try calling him now just to make sure. do you want me to give you directions? you can ask burntire. Paul is a good guy.

[silver03cobra]

Directions. take the 10 to the 51 north get off an northern go west(left) go to 7st go north (right) go 1 mile to cave creek/ Dunlap head north east (long right) stay in the right lane after you pass the light hatcher it will be like 1/4 mile north. It is connected with the auto shop called "in the motor car".
The sign is brown with yellow writing. Kinda small.

[IMSHAKN]

If I can't find something closer, I'll probably be going out to visit him. Thanks for the input and directions.

Now if anyone knows of anything else, let me know.

[BurnTire]

Paul is a great guy and very through. First time I was there he was working on a set of alcohol funny car heads for a top local car.

[Raggety64.5]

Try Basko Engine Service 480-921-1128. He is right there in Gilbert.

[silver03cobra]

+ 1 on Basko they are good too. There old guy used to work for paul until he went to diesel only. NOT SURE WHAT THEY CHARGE.

[silver03cobra]

Those heads are on the FASTEST SCFA funny car to date. AKA chill factor

[IMSHAKN]

thanks for the tip on Basko, I'm definitely going to call them up tomorrow morning. I really would love to have the flywheel done as close by as possible.