PDA

View Full Version : my secret turbo project



cardude99
11-24-07, 02:55 PM
for now and the sake of my tranny, im just gonna run 9lbs of boost but when i have enough money to replace the tranny if it fails i will up the boost to 12lbs.

Dave will be able to describe the exhaust situation better than me but ill give it a shot. my exhaust setup will not work with this turbo kit, so dave rigged it up so that the y pipe comming from the down pipe is connected to my exhaust (yes its still dual) and the other part of the y pipe is open. yes thats right open down pipe exhaust. its basically like open headers, just not quite as loud but still pretty freeking loud. i hope i like the sound cause i cant afford new exhaust for months.

this is just phase one. phase two will hopefully happen between mid dec and early jan. i will be adding an 8.8 rear, with 3.31 gear ratio ( i like my gas mileage), also phase two will also include a ph drive shaft that flapjack is selling me, and the lca's and ucs that he also sold me. a hurst short throw shifter might happen but at this point im not sure. until i complete phase 2 and get a fire jacket and helmet, i will not be drag racing, unless someone lets me drive theire car lol. its gonna suck not racing for a while but hey i do have a turbo now to tide me over.

after phase two performance mods will be done for a while and ill start working on appearence. by may or early june i will fix the exhaust if i dont do it sooner, but it will be the cervini cseries side exhaust. as of right now thats is far as i have it planned out. we'll see how it all goes and if i get any curve balls thrown my way.

i would like to thank Lance for selling me the kit and talking to me on the phone about concerns and anything else reguarding the turbo. i want to thank Dave for giving me advise through out this entire project, and of course for instaling it. and i want to thank Mike(power house) for helping out by checking the turbo out and helping me out with anything i needed even though i didnt get it from u.

well i love the kit, its so powerful, though i blew my clutch on the dyno, so i cant really go above 3k, but im getting a new one installed next week, then a new dyno tune maybe, only if its needed or ill wait, my temp dyno numbers are 310 hp and 423 tq (to the wheels) with my failing clutch

AZSonicSnake
11-24-07, 05:57 PM
sounds like fun! as you would expect us to ask....any pics? :twothumbsup:

4Jenna
11-24-07, 06:22 PM
Sounds cool....to bad the "secrets" of the kit arent revealed in the post so I wont ask any questions.

My turbo stang always ate clutches also.

fazm
11-24-07, 07:15 PM
same kit as mine, as i installed it :)

cardude99
11-25-07, 11:06 AM
Sounds cool....to bad the "secrets" of the kit arent revealed in the post so I wont ask any questions.

My turbo stang always ate clutches also.
the secret was that i had been planning this for about
months and i didnt tell anyone until it was installed

cardude99
11-25-07, 11:09 AM
http://i227.photobucket.com/albums/dd190/cardude9/1123071056b.jpg?t=1196010459
http://i227.photobucket.com/albums/dd190/cardude9/1123071056a.jpg?t=1196010470

http://i227.photobucket.com/albums/dd190/cardude9/1123071056.jpg?t=1196010527

AZSonicSnake
11-25-07, 12:48 PM
very nice!

fazm
11-25-07, 12:57 PM
damn, thats a nice ratchet, is that snapon? lol

LSlayer
11-25-07, 02:46 PM
Is that a powerhouse kit?

LSlayer
11-25-07, 02:48 PM
My bad just read through your first post again.

MinGry03
11-27-07, 03:17 PM
Nice, but clean it...

cardude99
11-27-07, 05:55 PM
Nice, but clean it...
it gets dirty to quickly here in az, i would have to clean it like 2 times a week, not worth it in my opinion