PDA

View Full Version : New build starting


6Jeff6
09-20-07, 12:37 PM
With all the bad stuff atleast my new build will be starting!!!:woot1:

Getting the block tomorrow and should be ordering parts to upgrade the heads by the end of this week.:bounce:

I'm shooting for 10's and totally streetable.

Standard Machine is doing the whole motor build(port and all).

Thanks to chris(4Jenna) for pointing me to a great shop.:twothumbsup:

I'll keep everyone posted.


Jeff
Ruckus46gt
09-20-07, 12:55 PM
guessing this is for the 2.2 kb car in your sig. Cant go wrong with heads from modular powerhouse well proven, but he wont release specs but will put money on it you wont find a head that flows better then his (stage 3's)
Gene
09-20-07, 02:20 PM
guessing this is for the 2.2 kb car in your sig. Cant go wrong with heads from modular powerhouse well proven, but he wont release specs but will put money on it you wont find a head that flows better then his (stage 3's)

I dont think he will be doing business with them again.
6Jeff6
09-20-07, 04:13 PM
Standard Machine will be doing all the porting and building of block. I want something that works and is done correctly.:twothumbsup:


Jeff
4Jenna
09-20-07, 04:28 PM
They ported my heads 130+mph traps on 6psi:woot1:
6Jeff6
09-22-07, 11:16 AM
Bill showed me one exhaust and valve port and omg this thing is going to flow like a mother.:woot1:


Jeff
6Jeff6
09-27-07, 11:22 AM
The stuff for the heads should be ordered. Finally good springs so I can rev higher!!!:twothumbsup:


Jeff
4Jenna
09-27-07, 11:46 AM
I was checking your shortblock out last night:hyper:
6Jeff6
09-27-07, 11:48 AM
I was checking your shortblock out last night:hyper:


I sure hope the fitting idea will work for the water pump.

Did they dip it???:pepper:


Jeff
4Jenna
09-27-07, 11:57 AM
Not yet
6Jeff6
09-27-07, 12:05 PM
They were waiting for another block to dip with it. Must not have that one yet.
I'll have to take my flex plate and misc. stuff down one of these days and check out how stuff's going.


Jeff
4Jenna
09-27-07, 12:29 PM
I'm not totally sure honestly, I just saw a 4.6 motor there and asked if it was yours.
6Jeff6
10-22-07, 12:58 PM
Flow numbers on heads were 215 and 183 totally noncorrected in nonairconditioned room. They do a 5-10% correction for altitude and depending on heat. It was midday so I used 8% and get 230 and 195-200. I'm stoked. This blower is going to get a workout.:twothumbsup:

Standard Machine has done this porting.


Jeff
4Jenna
10-22-07, 01:40 PM
:woot1: