BLK03SVT
09-06-07, 11:58 PM
So I finally got my CDC light bar installed on the cobra last night. Overall the install was pretty straightforward. I won't lie, there were a few curse words here and there, but nothing a cold heinekin couldn't handle. Overall it took about 4 hours. I now need to either replace the seat belt loops or do the mod as suggested in the kit, as they do interfere with the bar. I'm leaning towards ordering the smaller loops and replacing the stockers.
Only real issue I had (have) was the instructions call the rear brake light wire to be solid green, when in fact its more of a teal color (there are other solid green wires). The connectors supplied with the kit are cheap and I'm going to replace them with a higher quality connector.
Drilling holes in your factory interior panels isnt ideal, but if the templates are laid down right they line right up.
Here's a few pics. I haven't detailed the car yet so the finger prints are apleanty....
http://img.photobucket.com/albums/v229/azmpf/DSC02536.jpg
http://img.photobucket.com/albums/v229/azmpf/DSC02529.jpg
Only real issue I had (have) was the instructions call the rear brake light wire to be solid green, when in fact its more of a teal color (there are other solid green wires). The connectors supplied with the kit are cheap and I'm going to replace them with a higher quality connector.
Drilling holes in your factory interior panels isnt ideal, but if the templates are laid down right they line right up.
Here's a few pics. I haven't detailed the car yet so the finger prints are apleanty....
http://img.photobucket.com/albums/v229/azmpf/DSC02536.jpg
http://img.photobucket.com/albums/v229/azmpf/DSC02529.jpg