Quick ? on MIL Eliminators

[Steve2000GT]

I just put a bbk offroad x pipe on my 2000 GT a month ago... the check engine light came on and I know it was because I didnt have MIL's on the vehicle yet. They go on the rear sensors correct? and is that check engine light a hard code that will be stored in the system and need to be erased with an OBD 2 machine, should it turn off when the MIL's are plugged in, or will simply disconnecting the battery and reconnecting turn the light off once they are installed. I connected the MIL's today and the light was still on.. disconnected the battery and reconnected and it was off but i dont know if the light will come back on.

Thanks for any input

-Steve

[SloSVO]

the disconnect of the battery will clear the code and the KAM (keep alive memory) al that means is you'll need to drive it for a bit to clear a the OBD2 monitors before you go out and smog it.. if you don't have to smog it.. then your good to go..

[Steve2000GT]

sweet thanks... also will i need this catted h-pipe ever again? do they look under cars for cats at emissions stations

[SloSVO]

If you have the room I'd keep it you never know..unless you make your mind up to just have to buy a used one if you ever do.. i got the space so I got mine.. of al my cars...

[gip99gt]

Keep it you never know when you might need it.